CF Moto 800 MTX tuning Bosch ME17.8.10 with TunerPro xdf.
New TunerPro bin definition files (xdf) series containing engine tuning maps for CF Moto 800MT-X (Ibex 800) with ECU Bosch ME17.8.10 also called MED17.8.10.
The MT-X uses the KTM-designed, 799cc LC8c parallel-twin engine that’s manufactured for both CFMoto and KTM at the two companies’ joint venture factory in China for use in the KTM 790 Duke/Adventure, Husqvarna Svartpilen 801, and the CFMoto 800NK and Ibex.
With our XDF it’s possible manage the main fuel maps, ignition (optimal, base and knock sensor), torque monitoring, driver desire torque for each riding mode, throttle angle, exhaust gas temperature, volumetric efficiency and maximum rpm limiters.
Knowledge, experience, calibration studies and bench tests are the starting point for the development of the above mentioned bin definition files (xdf).
A free chiptuning software combined with competitive prices (70 euro) are the milestones of our philosophy.
Through the definition files, the remapping software TunerPro identifies the engine working parameters which allow to obtain the maximum power and torque without affecting the degree of reliability.
TunerPro is a binary files editor, not able to read and write the engine control unit. To do this, you need an external tool. We don’t provide information about these tools.
Prices
Prices (70 euro) and supported vehicles are available in the main motorcycles bin definition files area.
Read more about our Terms & Conditions.
Buy the XDF from our shop.
Learn more about tuning maps meaning.
Dyno Tests
Example of Stage1 on CF Moto 800MT-X: +5hp / +5Nm
TunerPro available maps
Please note: the maps listed may not be present in all vehicles because of the different software update and calibration numbers.
- Fuel: nominal lambda for component protection, lambda driver’s request.
- Ignition: knock detection factor characteristic curve cylinder counter, optimal ignition advance-angle map, ignition advance-angle characteristic map, minimum ignition advance-angle map.
- Torque: torque monitoring by accelerator position, maximum torque, map for engine speed dependent torque, optimum engine torque, lookup table minimum defined efficiency, relative driver desire torque – Off Road, relative driver desire torque – Rain, relative driver desire torque – Standard.
- Throttle: standardised air mass flow through throttle valve, desired throttle angle.
- Temperature: calculated exhaust gas temperature.
- Air Calculation: volumetric efficiency, map for calculation of nominal charge.
- Special Functions: RPM limiter.
