CF Moto Z10 Turbo Bosch MG1UA008 TunerPro xdf.
New series of TunerPro BIN definition files (XDF) featuring performance tuning maps and speed limiter removal for CF Moto ZForce Z10 1000 turbo 3 cylinders equipped with ecu Bosch MG1UA008.
Supported vehicles:
- CF Moto Z10 1000 Turbo 3 cylinders
- CF Moto ZForce 1000 Turbo 3 cylinders
Knowledge, experience, calibration studies and bench tests are the starting point for the development of the above mentioned bin definition files (xdf).
A free chiptuning software combined with competitive prices are the milestones of our philosophy.
Through the definition files, the remapping software TunerPro identifies the engine working parameters which allow to obtain the maximum power and torque without affecting the degree of reliability.
Please note: the maps listed may not be present in all vehicles because of the different software update and calibration numbers.
Contact Tuniverse for purchase
Dyno Tests
Example of Stage1 on CF Moto ZFORCE 1000 Turbo 3 cylinders: +50hp
TunerPro available maps (example of CF Moto Z10 1000 Turbo)
- Fuel: requested lambda, lambda target for component protection, lambda target for component protection – closed loop, minimum setpoint value for component protection, fuel base map.
- Ignition: knock detection factor characteristic curve cylinder counter, optimal ignition angle map, ignition advance-angle characteristic map, minimum ignition angle.
- Torque: optimum engine torque.
- Throttle: real mass flow over throttle valve, desired throttle angle.
- Temperature: simulated exhaust temperature.
- Air Calculation: map for calculation of nominal charge.
- Boost: limit for maximum desired air charge depending on intake manifold pressure, compression ratio for protection overspeed of supercharger, max Torque by RPM and Gear – boost related, max Torque Limiter – boost related.
- Torque – Ride by Wire related: Torque – Ride by Wire related – Trail, Torque – Ride by Wire related – Comfort, Torque – Ride by Wire related – Sport.
- Fans Control.
- Special Functions: RPM limiter, RPM Limiter by temperature, Speed limiter (H + L).
