Goes ATV remap Bosch ME17.8.10 with TunerPro xdf.
New TunerPro XDF for Goes ATV with engine control unit Bosch ME17.8.10 also called MED17.8.10 and ME17.U.6.
Supported ATV:
- Goes Terrox 1000
and all new Goes quad with ecu Bosch ME17.
Knowledge, experience, calibration studies and bench tests are the starting point for the development of the above mentioned bin definition files (xdf).
A free tuning software combined with competitive prices (70 euro) are the milestones of our philosophy.
Through the definition files, the remapping software TunerPro identifies the engine working parameters which allow to obtain the maximum power and torque without affecting the degree of reliability.
TunerPro is a binary files editor, not able to read and write the engine control unit. To do this, you need an external tool. We don’t provide information about these tools.
Prices
Price for each xdf: 70 euro.
Supported vehicles are available in the main ATV bin definition files area.
Read more about our Terms & Conditions.
Buy the XDF from our shop.
TunerPro available maps
Please note: the maps listed may not be present in all vehicles because of the different software update and calibration numbers.
- Fuel: nominal lambda for component protection, lambda driver’s request.
- Ignition: knock detection factor characteristic curve cylinder counter, optimal ignition advance-angle map, ignition advance-angle characteristic map, minimal ignition angle.
- Torque: optimum engine torque, relative driver desire torque from driving pedal – low power, relative driver desire torque from driving pedal – high power.
- Throttle: standardised air mass flow through throttle valve, desired throttle angle.
- Temperature: calculated exhaust gas temperature.
- Air Calculation: volumetric efficiency, map for calculation of nominal charge.
- Special Functions: RPM limiter, RPM Limiter 4WD, Speed limiter 2WD (H), Speed limiter 4WD (H), Speed Limiter L.
